Description: 10SI 6 Volt Negative Ground Rebuild/Conversion Kit This is the kit you need to rebuild your stock Delco 10SI alternator & convert it into a 6-volt negative ground self-excited or 1 wire alternator. This kit includes all the new parts as shown in the picture. Rectifier, diode trio, brush holder with 2 new brushes 2 springs & retaining pin, pulley end 6203-2RS bearing, slip-ring end needle bearing, 6-volt self-exciting voltage regulator, battery Stud kit, regulator port block off plug, & 4 new screws 2 insulated & 2 plain. Fits all OEM 10SI automotive alternators. I have many other kits listed. If this kit does not meet your needs, check out my eBay store or feel free to ask questions. Note; A 1 wire configuration IS NOT recommended for low RPM engines. The engine must be revved up once at start up to excite the alternator. The RPM needed to turn the alternator on will depend on the overall condition of the alternator, how well the rotor and stator are matched to each other, and Pulley sizes. Note; This regulator can be used for 1 wire or 3 wire wiring configurations. Once the alternator is complete and installed on the vehicle you may need to excite the alternator for the first time. HOW TO EXCITE A 1 WIRE ALTERNATOR to excite the One-Wire (Self Exciting) alternator you run a jumper from the post (positive power) to the #1 spade terminal on the alternator. With the motor running, you momentarily touch the jumper from the case to the #1 terminal, and then the alternator should start charging. After you have run the vehicle for a bit at above idle speed the voltage should build to the regulators set point. You can touch the jumper between both the #1& #2 terminals. Once you excited the alternator, you should be able to turn the motor off then restart and rev the motor and the alternator will start charging. If you have any questions, feel free to ask. All items are in stock & ready to ship. Items ship out the same or the following business day. All customers will receive a USPS tracking number.
Price: 42.95 USD
Location: Urbana, Ohio
End Time: 2024-01-22T23:42:52.000Z
Shipping Cost: 10.2 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
Returns Accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money back or replacement (buyer's choice)
Modified Item: No
Custom Bundle: Yes
Type: Alternator Repair kit, 1 Wire
Voltage set point: 7.8 Volts
regulator type: 1 wire, self-exciting
rectifier diod rating: 25 Amps each per 6
Drive end bearing: 6203-2RS
slip-ring end bearing: closed end needle bearing
Manufacturer Part Number: Does Not Apply
Drive end bearing size: ID: .669in OD: 1.575in Width: .472in
Non-Domestic Product: No
Bundle Description: custom alternator rebuild kit
Universal Fitment: Performance/Custom
Brand: Regitar, USI, or Transpo
Manufacturer Warranty: Unspecified Length
