1950's style Northern Electric 203D non-dial 3-slot working payphone

Description: 1950's Northern Electric N203D(similar to Western Electric) 3-slot payphone This phone is in working order. It is wired to work (talk and listen). Since there is no dial, it cannot be used to dial out. It is not equipped with a ringer, so it will not ring on inbound calls. On the side of the top housing is printed "N203D." On the backboard it says "QSD3-A" in red paint. The nameplate in the bottom left corner is typical Northern Electric. The F1 handset (1930's-1940's style) handset says "Northern Electric Company Limited" with patent numbers and "Made in Canada." On the top is a sticker that indicates our former employee Fred Sacia worked on this phone. The date on the sticker is 8-2-90. Fred worked for us at Phoneco for about 20 years or so, and he was an expert at wiring payphones. The coin return button seems to function normally. The direction card frame has an arch at the top, making it stand out from the more common square frames. Directions on the card say "Do not deposit money until requested to do so." The number of this phone listed on the card was 76PO. The coin return bucket is chrome. The phone has the proper Western Electric type stainless steel channel. There is no coil relay in the bottom tray and no network. The vault is covered by a snap-in door (no lock). Very likely this phone was used in a rural area where dial telephone service had not yet been implemented. The style is reminiscent of the earlier days before dials existed on payphones (1912-1920). When using this phone back then, a telephone company operator would ask the caller "What number are you calling?" and would then connect the caller to the other party. We encourage you to click on our seller ID for more information about us. Repro Doors : Thick flat aluminum doors, I may need to get more of these made. But I can't make old doors; and I don't know where to buy them; and at 88, not terribly concerned (in July 2024). The thick flat aluminum doors we can “glue” a wood block on to the inside of it and hook the spring inside the vault. We'll probably keep using these in chrome payphones unless you say something. Doors for Payphones : Recognizing in April 2021 the need for a conservative approach for doors, locks and a key, I began thoughts on what to do. If you have an old vault door on your payphone, an original lock with key will cost $65 extra, a modified lock and key will cost $55 extra. About old doors : If you are discriminating about them let us know. If you want to lock the vault for any reason, we need to know, and to discuss your options. Click on our profile for information. To have an old door with original lock and key would be to have a Northern Electric – Western Electric style (I call N.E. “Canadian Western Electric “ since they are so much the same) and were began with the help of Western Electric or/and Bell engineers) and would cost $73 additionally. One of the challenges we face is that seldom, the Automatic Electric and Western doors don't always fit in good, interchangeably wise; there's a little snag in each one fitting the other well. I don't know much more than that about any of this. Old doors without locks or with locks absent keys : We can put a spring on the back side and hook it inside the vault. $43 additionally. Call me, I'll enjoy sharing what I know about Automatic Electric ( 1912, 1920s – 1972) 3-Slot payphones. Parts interchange between 1912 and 1972 (over 60 years of extreme interchangeability). A.E. (Automatic Electric) and N.E. (Northern Electric 1954-1972) both ceased manufacturing of the 3-slotter in 1972. There isn't anything particularly remarkable about this payphone. It is rather ordinary, in use in booths in non-urban (not large metro) areas such as Peoria, Lacrosse, and the likes and rural cities and villages. Most of A.E.'s manufacturing was Chicago but they ventured into suburbia such as Northlake, IL shortly after 1955 labeling some of the payphones as made in Northlake. There's more to the history I'd gladly share. This payphone has not had a line cord hooked up so that you can plug it in (even with a cell phone) to operate. We can do this if you want. The vault (money) “door” is a 2020 aluminum cover and I can accommodate a lock-key door if you want for additional $. The name brands stamped into payphone through the years were Gray, Western Electric, Automatic Electric and Northern Electric. Automatic Electric bought Gray out in 1948. There after until the end (1972) A.E.'s name appeared on the front of their payphones. A large population lived in large cities where Bell used Western Electric telephones. These folks therefore think that payphones were Western Electric or Bell. But if you could count all the payphones that came out of booths when the Single Slot replaced them, you would probably find that over half were A.E. and the other half W.E. This phone does not have a plug-in cord so it is not capable of immediately working to dial out, talk-listen. I can have this accomplished for an additional $75 and with a $78 adapter will work on a cell phone line or telco line. The vault cover is a manufactured piece of aluminum. For $43 additional, you can get an old door held in by a spring. For $60 you can have a door with a modified lock and key, and for $73 an original lock and key in the old door. Automatic Electric bought Gray out in 1948 and there after until the end 1972, A.E.'s name appeared on the front of their payphones. I will continue to list payphones on eBay until I die or until they are all gone. If someone buys them all before either of those things happens, so be it. If payphones are left after I'm gone, there may be someone come along to see them pass off somewhere. As I visit this subject, it is though they sit around in a warehouse situation, but this is not real. They are apart. I am referring to two main situations: one where by these are the remains of hundreds that were taken apart 30 or so years ago, refinished and not yet ever re-assembled. A well known payphone collector and wheeler dealer Paul died earlier last decade. Paul would have been 86 in January 22, 2021 a month younger then myself. The manager of his estate sold to me 200 tops, 200 bottoms and 200 backboards. About 70 are left (7-2021). Each piece went through an ordeal. The beige or black pieces were repainted. The chrome pieces were polished. Almost all of the old painted bottoms have been sold; gone. We are now left with chrome bottoms both Western Electric style and Automatic Electric. Both 1948 style A.E.'s and 1955 – 1972 A.E.'s. There are still about 15 1948 style bottoms (chrome) and 15 1930s – 1954 tops remaining. There are enough pre 1956 backboards to accommodate these phones, a few 1956 – 1972 chrome bottom housings (7-2021). All this stuff lately gets put together. We used to wire them all up to work. Since several years ago, we've now simply assembled them with what we have and not made them work except by request. In around 1997 or 1998, I engaged a manufacturer to make replica tops (replica of 1920 – 1926 tops and 1932 – 1939 Western Electric bottoms). I demanded fairly exact replication to imitate the era they were to represent. If any of these parts are used, I will label. You will be informed of their use. Assembling these old payphone units is not a simple quick task. There is much involved which I'd gladly share if you would call me afternoons – evenings. It is a time involved time consuming project; and making them work correctly is another involved project. In the early 2000s, while we had Levi with us (from 1991 until 2018) we did up some genuine Western Electrics that well represented 1940 – 1956. These had original numbers 181, 183, 191, 193, 197, 200, 203 and 223. A few yet remain. That's it! I will not pursue the acquisition or investment into old payphones again in my life. Assembling all the parts is slow and tedious. We may run out of old coin gauges and that may end our offering, unless I find more old ones or get someone to make them. I have a small work force for 20 – 22 hours a week, so not many (maybe 2 or 3) can be offered per week. Please be sure to read the description as the payphone is sold as shown and described; and if you have any questions please call us at Phonecoinc. No returns. We are not responsible for your mistake for not reading our description. Review images for representation of item(s) you are purchasing. If you would like combined shipping, please wait until you have received your final invoice before making payment. If you have any issues with item(s) after receiving, please contact us before leaving negative feedback. Your business is greatly appreciated! Shipping applies to the lower 48 States, please send an email if you have questions or to request shipping charges for International shipping, and shipping to Alaska, Hawaii and Puerto Rico which will cost extra as determined by weight and size. Orders outside the United States will be shipped the most economical way available to us, and costs may be higher than the shipping cost shown on this listing.

Price: 239 USD

Location: Galesville, Wisconsin

End Time: 2024-09-12T02:56:38.000Z

Shipping Cost: 58 USD