EBC-B20H 12-72V 20A Lead Acid Lithium Battery Capacity Tester Support External

Description: Specification: Name: EBC-B20H battery capacity tester Voltage: 100-240V Power: 1700W Packing size: 55*36*30cm Weight: 9.4kg Volume weight: 11.88kg Bill of materials: 1pc tester, 1pc cable, 1pc power cord, 1pair of test clips Power supply mode: AC 100-240V Voltage setting: 9.00-88.00V, minimum step 0.01V Discharge current: 0.10-20.00A, minimum step 0.01A (12V battery pack maximum 10A) Discharge mode: DSC: Constant current discharge, automatic stop when the voltage is lower than the set termination voltage CHG: Charging by external charger, the current will stop automatically when the current is lower than the set termination current Voltage measurement: 0.10-89.00V , accurate to 0.01V, error +-0.5% Current measurement: 0.10V-20.00A , accurate to 0.01A, error +-0.5% Capacity measurement: Within 10Ah, resolution 0.001Ah 10Ah-100Ah, resolution 0.01Ah Above 100Ah, resolution 0.1Ah Wiring method: four-wire detection, voltage measurement and current channel separate wiring to ensure measurement accuracy LCD display: test data of voltage, current, capacity, time, etc. Computer connection: dedicated USB to TTL serial cable. Computer control, drawing curves, calibrating measurement benchmarks, upgrading device firmware,cycle charging and discharging, etc. EBC-B20H is a battery pack capacity tester for battery capacity test in the range of 12V-72V, built-in discharge load resistor, support charger for external battery pack, automatic switching charge and discharge, support computer online drawing curve . Picture showing : 1. Discharge test, connect the battery pack to the "battery" interface of the tester through wire clamping. 2. Charging test: In addition to connecting the battery pack, it is also necessary to connect the output end of the charger that comes with the battery pack to the "charger" interface of the tester. When the tester starts in charging mode, it internally connects the charger output to the battery for charging. When the charging current is detected to be less than the set value, it is judged as fully charged and disconnected from charging. (The tester does not control the charging current and voltage, only performs detection and on-off control). 3. Automatic charging and discharging, the tester supports a maximum of 5 steps, each of which can be in charging mode (requires an external charger) or discharging mode. By setting multiple steps, charging and discharging tests can be automatically carried out. When connected to a computer for use, software can be used to control startup and record voltage and current curves. Product Details: 1. One tester 2. One online line 3. One power cord 4. Test a pair of clamp wires Notice : 1.Regarding import duties: If the customs points out that taxes and customs clearance must be paid, the buyer needs to pay the duties. We do not bear any duties or import taxes. If the buyer is unwilling to pay customs duties and customs fees, we will not refund. 2.About customs clearance: For countries that are difficult to pass through customs, such as: Brazil, Chile,Turkey, Argentina, etc. Make sure you have the ability to pass customs. We do not give a refund if the buyer cannot go through customs and Customs deducts the package. 3.If your place is remote ,then need to pay 38usd .

Price: 296.49 USD

Location: China

End Time: 2024-12-02T10:37:29.000Z

Shipping Cost: 199 USD