Description: This is a set of connector housings, seals, and crimp connectors for certain Mopar electric power steering pumps used in various 2011 and up Dodge/Jeep/Chrysler cars and trucks. These are the factory connectors sourced from the factory suppliers. All our products are assembled by hand in the United States. Beware of the cut rate kits that are now on eBay! These kits use a smaller main power terminal that will not work with the 6 AWG wire needed for this pump. If the kit you are looking at comes with brown or green generic silicone seals, it does not use OEM quality parts and are not worth the risk. You will get the main power connector with two seals and two terminals and the data connector and three terminals as shown in the pictures. The main power terminals are designed for 4 mm2 to 16 mm2 wire roughly equivalent to 11 AWG to 5 AWG. The seals are the teal versions and are designed for wire with an outer diameter of 7.3 mm (0.29") - 8.3 mm ( 0.33"). Depending on the length of wire you need, 6 AWG wire with decent quality cross-linked polyethylene insulation (SGX, etc.) should fit fine depending on your supplier. PVC insulation will probably also work but is less desirable for under hood installations. Some EPDM (SGR, etc.) may also work. You should be able to also fit 4 AWG with STX (cross-linked polyethylene) insulation as long as the outer diameter is under 8.3 mm. I have a limited supply of the pink seals that will fit wire with an outer diameter of 6.2 mm ( 0.25") - 7.3 mm (0.29"). Message me if you prefer the smaller seals. The data connector terminals are designed for 0.6 mm2 to 1.25 mm2 wire (roughly 18 AWG wire). The seals are designed for wire with an outer diameter of 1.8 mm to 2.4 mm (0.07" - 0.09"). Please check out the picture of the connectors on the pump to make sure these will fit. With these connectors you can build your own wiring loom to fit your car with no splices. You can also use these to install the electric power steering pump in any vehicle. Please note that all available data indicate that this pump will not run without being connected to the CANbus. If you are looking for a high quality, reasonably priced crimp tool for the large terminals, I can recommend the Iwiss 5100A. It can be found online for around $50-$60 shipped and makes excellent crimps. The large power terminals take a little force to crimp, and the seal crimp can be tricky. If you prefer to buy a fully assembled wire harness, please see my other ad: https://www.ebay.com/itm/264926638094 For a controller that will allow you to adjust the steering assist and enable speed proportional steering check out the NMSTEC controllers in our store: https://www.ebay.com/itm/266145679940 If you are looking for a steering connector and you don't see it, feel free to message me.
Price: 39.99 USD
Location: Austin, Texas
End Time: 2024-01-07T00:19:30.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
Returns Accepted: Returns Accepted
Item must be returned within: 60 Days
Refund will be given as: Money Back
Performance Part: Yes
Country/Region of Manufacture: United States
OE/OEM Part Number: NA
California Prop 65 Warning: WARNING: This product contains a chemical known to the State of California to cause cancer.
Type: Power Steering Connector
Features: Sealed
Manufacturer Part Number: Does Not Apply
Fitment Type: Direct Replacement
Greasable or Sealed: Sealed
Part Type: P/S Control Module Connector
Universal Fitment: Yes
Placement on Vehicle: Universal
Brand: Select Electrical Connectors
Drive Type: Electrical
Items Included: Connector
