MCD Elektronik UMS1300KS Universal Measurement System UMS +(2) 96-Ch MUX cards

Description: MCD Elektronik Universal measuring system UMS1300KS The MCD UMS1300KS Universal Measurement System (MCD UMS1300KS) is a modular PC-controlled test system in 19 " technology, with application equipment. The programming is done by the MCD programs using the integrated interpreter via a computer system with USB or RS232 port. Includes control box as pictured with two 96-channel MUX cards as pictured. Only what is pictured is included. Not sure how to test it, so sold as is for parts/repair. System:RC-measurement board for resistance measurement / capacity measurement / voltage measurementDiode measurementmeasurement system for measuring short-circuit and component measurement for 96 channelsOptional:Channel expansion to 384 channels or rather 576 channelsResistance measurement:Through a DA converter the test voltage can beadjusted from 0. .2500 mV. When testing boards however, this test should not exceed 500 mV. The measurement sources, depending on the range has an internal resistance of 220 Ohm, 4k7, 100 kOhm.Measurement method: voltage dividerCapacitance measurement:Through a DA-converter, the test voltage for charging the capacitor can be adjusted from 0. .2500 mV. When testing boards however, this test should not be set higher than 500mV. The measurement sources, depending on the range has an internal resistance of 220 Ohm, 4k7, 100 kOhm.Measurement method: Condenser is charged to Uprüf. Then unloaded on Rv (220 Ohm, 4k7, 100 kOhm). He is discharged so long, until Uprüf / Uc <= 1 / 5. is reached. Simultaneously, the discharge time is measured.Diodes Forward Voltage:Through a DA-converter, the test voltage is set fix to 2500mV. The series resistor of the measurement sources can be selected between 220 kOhm Ohm, 4k7, 100thMeasuring method: Voltage measurementADW measurement:It is possible to switch between two modes of ADW's.1. Measuring Single-ended: at the POS signal, a voltage of + 18V can be measured to GND. At the same time a voltage of 0..10V can be stimulated on the NEG signal with a D/A converter. Calibration:The calibration of the measurements take place over EEPROM cells, which are described with corresponding offset and gain corrections.

Price: 331.65 USD

Location: Saint Paul, Minnesota

End Time: 2024-03-01T04:40:40.000Z

Shipping Cost: 5 USD