ORIGINAL 1999 2000 OEM Honda Odyssey KEYLESS REMOTE KEY FOB E4EG8DN G8D-440HA

Description: 1999 - 2004 Honda Odyssey 5 Button Keyless Entry Remote Fob -G8D-440H-A, E4EG8DNNEW RECASED WITHOUT THE WRITING ON BACK Fits: 1999 - 2004 Honda More Information VERY IMPORTANT YOU MATCH UP THE FCC ID NUMBER WITH YOUR WORKING REMOTE THERE IS ANOTHER ONE THAT LOOKS THE SAME BUT HAS DIFFERENT FCC ID NUMBER THEN BELOW. IF YOU DO NOT HAVE A REMOTE CALL THE DEALER PARTS DEPARTMENT UP WITH YOUR VIN NUMBER AND ACT AS IF YOU ARE BUYING ONE THEN ASK FOR A PART NUMBER AND THEN YOU WILL KNOW WHICH ONE YOU NEED FCC Number E4EG8DN G8D-440H-A OE Part #72147-S0X-A01, 72147-S0X-A02 Programming Information This remote comes with self programming instructions. You can view them under the 'Programming Instructions' tab. Product Condition NEW WITH NEW BATTERY Programming Instructions Obtain all remote transmitters for this vehicle and read the instructions prior to programming. Entering programming mode will erase all previously programmed remotes for this vehicle. You must have all remotes available for programming including working ones. Enter vehicle and close all doors Each of the following steps must be completed within five seconds of completing the previous step. If you take longer than five seconds or make a mistake, you must start the entire procedure over. Insert the key into the ignition, hold one remote in your left hand with additional remotes close by. We recommend taking remotes off the key ring to perform the procedure. When the instructions say to press the LOCK button, you should press the LOCK button on the remote for approximately one second then release it. Perform each of the next three steps in order, then repeat all three steps two more times for a total of three times each. 1. Turn the ignition to the ON position, marked II. 2. Press the LOCK button on the remote. 3. Turn the ignition to the OFF position, marked I. (Do steps 1-3 three times) Next, turn the ignition switch to ON position, marked II. 4. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has ENTERED programming mode. 5. Using the same remote, press the LOCK button again. The door locks should cycle indicating the vehicle has PROGRAMMED that remote. If you have other remotes to program then repeat step 5 with each additional remote one after another. Step 5 must be completed within ten seconds for each additional remote. You may program up to three remotes. 6. Turn the ignition to OFF. Test all remotes. If your remote has a trunk button you will need to hold that button down for several seconds for that function to operate.

Price: 25.99 USD

Location: Woodland Hills, California

End Time: 2024-12-11T19:02:22.000Z

Shipping Cost: 3.5 USD