Springfield Hellcat Mag Plate (Knurled Bump 7) Black, Gray, Red, Blue, Bronze.

Description: Compatible with Springfield Hellcat Magazine Plates models. Do not attempt to install on any other firearm platform.Disclaimer: This is NOT a product of SPRINGFIELD. This custom Bumper Grip is designed and manufactured by 3DCREATIONS as an accessory part/replacement for SPRINGFIELD BUMPER GRIP part.Disclaimer for Improper Use of PLA PartsThe information and recommendations provided regarding the use of PLA (polylactic acid) printed parts are intended to guide users in the correct use of the material. However, improper use or non-recommended conditions may result in performance and durability issues with the parts.1. Proper Use of the Material: PLA printed parts are designed for general applications under normal use conditions. Their suitability for extreme applications, critical support structures, or environments with high temperatures, extreme humidity, or exposure to chemicals is not guaranteed.2. Temperatures and Environmental Conditions: PLA has a relatively low thermal transition temperature, and its strength may be compromised if exposed to extreme heat or non-recommended environmental conditions. The user is responsible for ensuring that the parts are kept within the conditions specified by the manufacturer and are not used in applications that exceed their capabilities. PLA printed parts have significant limitations regarding temperature, as they can deform or lose their structural integrity if exposed to excessive heat. Here are some recommendations to avoid temperature-related issues:Avoid Direct Heat Exposure: Keep PLA parts away from direct heat sources such as radiators, stoves, and halogen lights that may emit significant heat.Proper Placement: If the part is to be placed in an environment exposed to high temperatures, ensure it is in a temperature-controlled area. Avoid prolonged exposure to direct sunlight.Service Temperature: Be aware of the maximum service temperature of PLA, which is generally around 60°C or 140°F. If the environment exceeds this temperature, the part may begin to deform.Proper Storage: When not in use, store PLA parts in a cool, dry place to avoid prolonged heat exposure that could compromise their structure.3. User Responsibility: Improper use of PLA parts, such as exposure to high temperatures, excessive load, or exposure to incompatible chemicals, can cause deformation, structural failures, or damage. The responsibility to evaluate and test the suitability of the parts for their specific use lies with the end user.4. Disclaimer of Liability: We do not assume responsibility for damages, losses, or consequences resulting from the improper use of PLA printed parts. This includes, but is not limited to, material damage, personal injury, or performance failures of the part due to unspecified or incorrect usage conditions.This bumper grip is specifically designed to be used exclusively with the 15-round magazine. It is not recommended for use with magazines of lower capacity, but it can be employed with magazines that have a higher capacity than 15 rounds.Made of hard plastic.Great design for ergonomic grip and better concealment.3D printed, good quality.MADE IN THE USA.Shipping:- Shipping will be within 3 business days after placing your order.- Delivery will take about 4 to 7 business days after shipping the package (most of the time). - Your address is your responsibility: in case the courier company (USPS or another) was unable to deliver the package because of wrong address, incomplete consignee address, addressee unknown, refuse to receive or any other reason that is the buyer fault, then after we receive the package back you will get a refund shipping fee. Thank you.

Price: 12 USD

Location: Pittsburgh, Pennsylvania

End Time: 2025-02-05T23:41:55.000Z

Shipping Cost: N/A USD