Stator Fits Kawasaki Voyager ZN 1300 1983 1984 1985 1986 1987 1988 ZN1300

Description: Free shipping in USA Same day shipping visit our store > find parts for : ATV / UTV / SXS Motorcycles Snowmobiles Watercraft Other Menu Store Home find parts for ATV / UTV / SXS Motorcycles Snowmobiles Watercraft Other IMPORTANT - Important notice about the product.--> Stator for Kawasaki Voyager ZN 1300 1983-1988 | ZN1300 | OEM Repl.# 21003-1064 KEY FEATURES Brand new aftermarket generator stator Higher grade of electric components. Highest grade copper windings, resistant to 200 degrees Celsius. All products shipped are tested DESCRIPTION Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced. *Beware, the KAWASAKI ZN1300 Voyager has two stators, this one is the smallest of the two (left side). See RMS010-102015 for larger one (right side). Please compare to your original part before buying. Brand new aftermarket generator stator You must re-install your original connector and grommet (see picture). Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install. Higher grade of electric components. Highest grade copper windings, resistant to 200 degrees Celsius. All products shipped are tested We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause for repetitive electrical issues. All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part. PAcked with these technologies --> Vehicle models fitment Kawasaki ZN 1300 Voyager -- 1983-1988 OEM part replacement 21003-10642112-030931401-01D10 Specifications Wire to wire resistance : Alternator : Yellow between each Yellow = 0.9 ohms+/-20% Alternator : Yellow to Ground = O.L. ON DISPLAY Dimensions : Interior diameter : 34 mm Exterior diameter : 93 mm Thickness : 27 mm Harness length : 800 mm Other specifications : Number of wires : 3 Number of terminals : 3 instructions Before installing your new generator stator Check the AC output of the stator. Replace any burned or corroded connectors on stator and regulator/rectifier Check and repair any melted wiring. Use hi-temp dielectric grease on all connectors Our stator may use a different wire color code than your original. All of the wires are installed in the correct order; please do not change any of the wiring configurations. This stator is designed as a direct plug-in replacement and should be used as such. When bolting stator in, always use locking compound. If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010??. Warning: Risk of electric shock. Disconnect the battery before servicing. Ensure proper installation by a qualified technician to avoid malfunction. SHIPPING We deliver 99.4% of our orders within the specified time period. If your item is not available in our main Colorado facility, we still guarantee that your order will be delivered within the specified time period. If your item is not delivered within this time period, we will offer you a 5.00$ discount on your order. This guarantee applies to shipments delivered in the 48 continental USA states, excluding PO boxes. Videos Racetech around the world --> customer service AsK seller a question duties & taxes International Buyers: Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. RaceTech Electric was founded in 2011 by three motorcycle industry veterans in San Diego, CA. The group has over 20 years combined in the Motorcycle industry. Customer servicePart request About usAbout seller pageAdd seller to favorite

Price: 139 USD

Location: Coaticook, Quebec

End Time: 2025-01-07T20:12:36.000Z

Shipping Cost: 0 USD